EN
12
1a
1b
6.1 VACUUMING - WET & DRY WITH WATER FILTER
Only vacuum non-flammable liquids such as water and
spilled beverages. Always clean the unit after using per the instructions
below.
To vacuum up liquids, you can begin with an empty tank!
If you need to vacuum large amounts of water use either medium speed
or maximum speed. The appliance can suckup up to 1.2 liters of liquid.
In excess of this quantity, the electronic safety switch is enabled making
a noise and the motor noise becomes more acute. At this point, turn the
vacuum function off immediately and empty the water tank before using.
Fill the water tank as described in Chapter 5 to vacuum solids or a mix of solid
and liquid waste. Choose the best accessory for the job. See Chapter 7.
To change vacuum power, hold the vacuum speed button on the grip (Pict.1a)
until the desired level is reached. If you are vacuuming dust or other kinds of
dirt, replace the tank water frequently.
Vacuuming
Follow the instructions above and then choose the accessory best indicated for
what it is you want to do (Section 7). Turn on and choose the desired speed.
Use the lowest speed for delicate materials and medium or high speed for most
other jobs.
Vacuuming liquids only
If you want to vacuum liquids, such as spilled water, there is no need to add
water first. You can start vacuuming directly. For best results use the following:
Medium speed - large amounts of liquids (e.g. a siphon).
High speed - small amounts of liquids.
Intelligent Boiler Technology (IBT)
The Carico Sanatizing System is the only unit available with IBT. IBT manages
power use between the steam and vacuum to save electricity and time. With the
steam function off, the vacuum has three (3) speeds. When the steam function is
on, the system has two (2) speeds.
6 - OPERATION
6.2 STEAM CLEANING & SANITIZING
Once the necessary boiler pressure is reached, the flashing blue light becomes
steady, and the steam function is ready to use. Insert the desired cleaning
accessory directly into the hose grip handle or with one or more extension tubes
in between. To deliver steam, just pull the steam power button on the handle
(Pict. 1a). To get the best steam output and turn vacuum off, start with the steam
regulator (Pict 1b) at minimum (-), then slowly turn up (t) until you
reach the perfect steam-pressure for your work. For further instructions see
Chapter 7 Accessories & Filters.
6.3 STEAM CLEANING & VACUUMING AT THE SAME TIME
When operating the steam and vacuum functions together you must FIRST
heat the boiler and do some steam cleaning in order to heat up the Flex Tube,
the Extension tubes and the accessory you are using. Only when the device is
fully heated (i.e., the blue light stays on) should you add the vacuum-function
to the steam function.
Speed
Button
Steam Power Button
WARNING!
!
CAUTION!
!
Steam Regulator
Summary of Contents for ULTRA TECH CLEAN MACHINE
Page 1: ......
