10
“Power+” +0500120IE - rel 1.1 - 02.05.2017
ENG
3.4
Drilling and assembly
Important:
During installation do not grab the plastic vertical braket, but rather the “solid” parts such as the heat sink and the
plastic base.
For installation with the heat sink outside of the panel (Fig. 3.f ), make a hole with dimensions of the dashed rectangle,
where the heat sink will be fitted, and holes for fastening the plastic base. These are inserted in the slots located in the
plastic base.
For panel installation (Fig. 3.g), refer to the following procedure:
•
bend down the tab metal sheet on the bottom of the carter (detail “A”);
•
use the holes on the upper side of the carter to hang the drive on the panel by using the two screws previously
fitted to the panel (detail “B”);
•
fix the bottom side of the drive to the panel with a screw through the hole on the tab metal sheet previously
folded.
Installation with heat sink outside of the panel
Fig. 3.f
Panel installation
B
A
Fig. 3.g
