Carel HDU05RM230, User Manual

Page: 19 / 22

Humidisk - user manual Rel. 1.2 del 18/03/99
15
5 Maintenance
Check periodically the air filter (10) and, if necessary, remove and clean it (fig.3). To remove the filter (10), see 5.1
below. The filter may be washed with water or cleaned with a vacuum cleaner.
Warning: do not use the appliance without the filter (10).
If you have to remove the fan (E) and the disk (F) in fig.4, first mark both the disk and the fan with a marking pen so
that you can reassemble them exactly in the same position. The fan-disk unit has been balanced in the given position.
IMPORTANT: if you have to change the power supply cable, please ask for an original one.
5.1 Removing and reassembling the filter
To remove the filter, unscrew the fixing screws on the bars (ref. 12, fig.3).
To reassemble the filter, first block one of the ends with the bar using the screws provided. Then take the other end
of the filter and the second bar at the same time and place them in fixing position. Hold down the bar so that it
clamps the filter against the appliance, then fasten the two remaining screws.
5.2 Storage
Keep the appliance in a place where the temperature ranges between -10°C and +60°C.
When the appliance is still in its package, keep the box in an upright position.
Do not pile other heavy material on top of the box.
5.3 What to do before and after long periods of inactivity
Before:
Turn off the general switch of the electrical panel and turn off the water supply tap.
Check the water tank. It must be empty.
Cover the machine to protect it from dust.
After:
The fan must turn freely without friction (to check this, lift the top part of the machine (fig.4) and push the red fan
(E) with your hand so that it turns).
The switch level of the float in the water tank must be able to go up and down.
The machine must be correctly installed.
5.4 Disposal of the product
The product is essentially made of plastic and metal, both recyclable. Before disposing of the product it is better to
separate the plastic parts (cover, fan, blades, etc.) from the metal ones (motor, tank, etc.).