Carel Compact ROC 140, User Manual

Page: 20 / 60

20
ENG
Mechanical installation WTS +0300130EN rel. 1.0 - 05.09.2022
5.2.5 Inserting the prefilter cartridge(s)
Before installing the filter set in the preffilter container, it must be ensured that the feed water line is closed and thus no
pressure is applied.
» Remove the filter container(s) using the screw driver supplied.
» Then install the new filter insert as shown.
» Refit the filter container(s) and screw tight.
Notice:
If there are two prefilters ( ROC-140), insert the green activated carbon filter first.
Prefilter and membrane position
Fig. 5.e
5.2.6 Inserting the membrane(s)
Before installing the membranes in the membrane container, it must be ensured that:
– the feed water line is closed and thus no pressure is applied.
– the unit is out of power.
ROC025/040/080:
» Unscrew the cap of the membrane container and install the membrane.
» Pay attention to the installation direction (black lip seal downwards).
» Make sure that the membrane is correctly inserted.
» Tighten the closure of the membrane container.
ROC140:
» Unscrew the two quick fasteners (1) on the left-hand side of
the membrane pressure pipe and catch the leftover water.
» “Remove the two Allen screws (2) and the half-moon shaped
fastening rings (3) from the slot of the membrane pressure tube.
1
2
3
3
4
5
4
» Pull the end cap (4) out of the membrane pressure tube.
» Pull out the membrane (5) from the left side of the
membrane pressure tube.
5
6
» Ensure the correct installation direction and insert
the membrane from the right side into the membrane
pressure tube (6).
» Put the end cap back into the membrane pressure
tube and fasten it with the half-moon shaped fastening
rings (3) and the Allen screws (2).
» Finally, connect both quick fasteners (1).
Notice:
Use disposable gloves when installing the
pre-filter(s) and membrane(s) to protect them from
contamination.
» Continue with the commissioning (chapter 8.1) and
flushing of the membrane.