C
AREFREE OF
C
OLORADO
I
NSTALLATION
M
ANUAL
OEM
A
SCENT
SC
&
SS
052553-011r6
10
I
NSTALLING THE
D
EFLECTOR
-
O
PTION
1,
D
IRECT
M
OUNT
The following instructions reference the preliminary layout done previously. Refer to "Option 1 - Direct
Mount of Deflector" under Preliminary Layout on page 2.
Figure 12. Installing the Deflector.
1. If closed, open the room approximately 3 inches. If open, close the room to approximately 3 inches.
2. Measure and mark the center of the room flange.
3. Lift one of the deflector halves up and set the rear protrusion on top of the flange as shown. Align the
inner edge of the deflector half with the mark made in step 1.
4. Attach the deflector to the room face using the #12 x 1 1/4 self-drilling screws w/ rubber washer.
Attach the ends first placing the screws 4"-12" from the end of the deflector
AND
into structure.
For box lengths less than 96":
Continue to attach by evenly spacing 3 additional screws between
the ends. Use a minimum number of 5 screws to attach the deflector.
For box lengths longer than 96":
Continue to attach by evenly spacing screws between the ends
approximately 24" apart.
NOTES:
Three screw groove guides are scribed into the deflector. Use the groove that best matches
the room's structure.
Before tightening the screw, seal the hole and head of the screw with a quality silicone
sealant.
5. Slide the shouldered spacer into the rear screw slot of the deflector.
IMPORTANT NOTE: The spacer must be between the deflector halves as shown. Failure to do
so will cause the other components (i.e. roller tube and cover) to not fit properly.
6. Lift the second deflector half up and slide onto the shouldered spacer. Position on the flange and
attach in the same manner as the first deflector half.
7. Thoroughly clean any shavings and debris from the deflector before proceeding to the next step.
as012
Top of
Flange
Flange Face
3” 2.5”
2”
24” (approx.)
#12 x 1 1/4 Screw
Hex Head w/
Rubber Washer
Screw Grooves
4”-12”
Shouldered Spacer
