C
AREFREE OF
C
OLORADO
I
NSTALLATION
M
ANUAL
OEM
A
SCENT
SC
&
SS
052553-011r6
14
I
NSTALLING THE
F
RONT
C
OVER
NOTICE
DO NOT attempt to open or close the room until the front cover is installed, closed and
fastened.
Figure 18. Installing the Cover.
1.
(Detail A)
Holding one cover half perpendicular to the deflector, lift and hook the cover onto the back of
the deflector. The splice plate should align with the center gap in the deflector.
2. Lift the second cover half up and hook onto the deflector.
3.
(Detail B)
Allow the two halves to hang down and align the splice plates. Attach the two halves using
two (2) #8-32 x 1/2 screws.
NOTE:
To prevent damage to the cover, use a ballpoint hex drive bit with a long extension. This will
allow the screws to be tightened using a power driver.
4.
(Detail C)
Rotate the cover up and secure using two (2) #8 x 1 1/2 shoulder screws. To properly
position the cover it will be necessary to press the cover toward the slat until the attach holes align with
end cap holes.
NOTICE
There will be a small gap between the cover and end cap. D
O NOT
attempt to close
the cap by over tightening the screw, maximum torque is 30 in-lbs.
as018a
DETAIL
B
DETAIL
C
Cover
DETAIL
A
#8 x 1 1/2
Shoulder Screw
(x2)
#8-32 x 1/2 Screw
(x2)
