CIMAN009 – Issue 1
Recline Operation
The tilting mechanism is operated via a full width bar located below the push handle.
1 - To release the mechanism pull the operating bar upwards.
2 - Holding the operating bar and handle push down until the desired recline angle is
achieved.
3 - Release the operating bar to lock position.
4 - Reverse the previous action to return the chair to upright position.
Armrests
Note: The armrests must not be used to help manoeuvre the Chair. Push
handles are supplied for this reason.
Folding Armrests
The armrest is a self-supporting arm.
To raise the arm lift / fold upwards.
To lower the arm pull / fold downwards.
Removable Armrests. (With Or Without Padded In-Fills)
These fit into a socket on the side of the Chair frame, located below the seat line.
1 - To remove the arm, release the hand wheel and pull / lift upwards.
2 - To replace the arm, Insert the tube end of the arm into the socket and secure
with the hand wheel.
3 - Padded in-fills, where fitted, should not be removed without a suitable
replacement arm or infill being available.
Footrest Adjustment
1 - Remove the pin clip or release the hand-wheel, (dependant on model), located at
the lower part of the legs.
2 - Select the desired footrest height by sliding the footrest assembly up or down.
3 - Refit the pin clip or secure the hand-wheel.
Note: ensure the footrest is correctly adjusted for the service user.
4 - Where fitted the optional fold-up footrest is height adjusted in the same way.
