R1
18
EX
20
Step 8:
Assembly of the Console and Bottle Holder
1. Connect the sensor cables (B1 & B2) with the cables of the console and slide the console (E) onto
the designated plate.
2. Loosen the preinstalled screws (J12) on the central support tube (B).
3. Mount the bottle holder (H7) to the central support tube (B) with the screws (J12).
Step 9:
Alignment of the Feet
If the floor is uneven, you can
stabilize the equipment by
turning the two setting screws
under the main frame.
1. Lift the equipment on
the desired side and
rotate the setting screws
under the main frame.
2. Rotate the screws
clockwise in order to
remove them and to raise
the equipment.
3. Rotate them
counterclockwise in
order to lower the
equipment.
After completing the asembly, check that all screws are tight!
Summary of Contents for EX20
