CARDIOSTRONG CST-TX40E, Assembly And Operating Instructions Manual

Page: 14 / 64

TX 40e
14
Problem: E9 appears on the display after you have used the treadmill for a few minutes.
Solution: 1. The upper and lower control cables are not correctly connected. In order
to solve the problem, please check the cable routing (circuit).
2. Please contact your contract partner and ask for technical customer service.
Problem: The treadmill automatically stops during training.
Solution: The treadmill does not record your steps, because it stopped running or
because the user weight is too low to detect the steps, in particular if an incline level
is set. One option is to go to the personal settings and turn off the INTELLI-GUARD
function (see 34).
! Warning: This releases the INTELLI-GUARD function, however, though it may
be necessary based on different variables.
Technical mode
Personal setting Information on the screen
Hold ENTER/MODE and then SPEED UP for three seconds to get
to the technical mode. First the software version will appear.
Then press ENTER/MODE to get to the personal settings or show
the factory settings.
200 ENG MODE
Setting the measurements - metric (Si) or English (E). Press SPEED
UP or DOWN to change between them. Press ENTER/MODE to
confirm the setting and to get to the next setting.
En or Si
Turn the INTELLI-GUARD on/off. INTELLI-GUARD stops the
equipment automatically if no steps are detected on the tread-
mill. Press SPEED UP or DOWN to change it. Press ENTER/MODE
to confirm the setting and to get to the next setting.
I-G
On or Off
Setting the pause time. Here you can set the time for which the
treadmill should stop before changing to the automatic settings.
The options are 90, 180 or 300 seconds until the console resets.
Press SPEED UP or DOWN to change it. Press ENTER/MODE to
confirm the setting and get to the next setting.
PAUSE TIME
90 or 180 or 300
Turning the acoustic alarm on/off !WARNING: The acoustic alarm
was set by the manufacturer in order to warn users when the
treadmill starts or the speed changes. The user may turn off the
alarm at one‘s own risk.
BZ On or OFF
Set up treadmill. Start speed after the PAUSE button was pressed.
0 indicates that the treadmill will start at the lowest speed. 1
indicates that the treadmill will start at the speed it had before
the PAUSE button was pressed. Press SPEED UP or DOWN to
change it. Press ENTER/MODE to confirm the setting and to get
to the next setting.
BZ On or OFF