![background image](http://html1.mh-extra.com/html/cardin/rpq-s504-series/rpq-s504-series_set-up-and-user-instructions_2555976014.webp)
14
Transmitters
The transmitter is pre-coded
and is fitted with an integrated circuit which is programmed in the factory
with a unique identification number. All the code parameters are contained in this integrated circuit. The
transmitter has an automatic shut down mechanism which cuts in after at least 20 seconds of continuous
use (this limits battery consumption).
Key block function
• A key block function has been added to protect the appliance from accidental
activation;
- to activate the function press and hold down “
MR
” for 8 seconds until the orange
led starts flashing, at this point to activate a command you will need to press the
required key three times consecutively;
- to reset the function to standard operation standard press and hold down “
MR
”
for 8 seconds until the orange led starts flashing.
Installation
Depending on the type of installation, work out the position in which the programmer will be situated
remembering that the site must be:
- installed indoors; a position safe from accidental collision and tampering and in a position which the
technician can easily reach.
• Remove the two holding screws and lift up the cover
• Using the container as a template mark the four points at which the fastening holes are to be drilled and
fasten down using four self-tapping M4 screws and relative rawplugs.
• Remove the two plastic cable protection covers.
1
2
MR
Summary of Contents for RPQ S504 Series
Page 55: ...55 Notes...