B-16 OPERATION B-16
WELDING IN STICK MODE
1 Put the electrode holder and cable quick connect
plug into the electrode output receptacle. Turn
clockwise until tight. Connect the work clamp to the
work piece.
2 Set the TIG/MMA switch to "MMA".
3 Set the MMA/TIG Switch to the MMA mode
desired for the type of electrode being used (most
commonly DC+).
4 Place the electrode in the electrode holder.
In Stick Mode the output terminal and electrode
will be electrically hot whenever the power
switch is turned on.
5 Turn the power switch to "ON".
6 Adjust the Current Control to the desired amps.
7 Strike an arc and weld.
NOTE: When the MMA/TIG switch is set to "MMA"
the output is always on when the power switch is on.
A remote control has no effect on the welding
current and the gas flow and high frequency TIG arc
starter are disabled.
RECOMMENDED ELECTRODE AMPERAGE RANGES
.
SMAW Process
Welding Amp Range for Stick Electrode Size
ELECTRODE TYPE
POLARITY
3/32"
1/8"
5/32"
E6010
DC+
40 -70
75 - 130
90 - 175
E6011
DC+
40 - 80
55 - 110
105 - 135
E6013
DC+
70 - 95
100 - 135
145 - 180
E7014
DC-
75 - 95
100 - 145
135 - 200
E7018
DC+
85 - 110
110 - 160
130 - 200
Stainless
DC+
40 - 80
75 - 110
95 - 150
Summary of Contents for Digi-Tig320ACDC
Page 27: ...B 13 OPERATION B 13...
Page 28: ...B 14 OPERATION B 14...
Page 29: ...B 15 OPERATION B 15...
