10
ASSEMBLE BAND SAW UNIT
Place the band saw unit on the stand,
fasten the stand to the band saw unit
with 3 set bolts (m1-1.5*16) as shown
in Fig.11
Fig.11
ASSEMBLE V-BELT
1. Loosen the 4 motor mounting bolts, raise the motor up, fitting the V-belt into the pulley grooves, then
let the motor down.
2. Place a slight pressure on the motor to tension the belt, then tighten the 4 motor mount bolts.
3. Make sure the motor does not twist and re-check the pulley alignment. Adjust the positioning
as needed.
ASSEMBLE SIDE COVER
Fit the 2 side covers inside the stand opening and attach
by turning the catch tabs over the edges of the stand as
shown in (Fig. 11-1).
ASSEMBLE TABLE GUARD
COVER AND BLADE COVER
1. Place the table guard around the throat of band saw
unit on the top edge with 2 knob screws of the guard
cover.
2. Place the blade cover around the side of the band
saw, covering the blade with 4 knob screws as shown
in (Fig. 12)
