Carbatec RT-RPU2400, Manual

Page: 13 / 28

CARBATEC.C OM.AU
RT-RPU2400
OVERLOAD PROTECTION
Before the motor is overloaded, the electronic
overload protection circuit will turn off the tool.
SOFT START
The Soft-Start feature reduces the amount
of torque reaction of the tool. This feature
gradually increases the motor speed up from
zero to the speed set by the variable speed
dial.
FEEDBACK CONTROL
The electronic speed control system allows
the tool to maintain constant speed between
no-load and load conditions.
!
To reduce the risk of injury, always use
feather boards, push sticks or push
blocks with proper guarding. Keep hands
away from moving bit. Refer to the Router
Table manual for proper table setup and
use.
CUTTING
The speed and depth of cut will depend
largely on the type of material being used.
Keep the cutting pressure constant but do
not use excessive force so the motor speed
slows excessively. It may be necessary
on exceptionally hard woods or problem
materials to make more than one pass to get
the desired depth of cut.
Before beginning the cut on the actual work
piece, it is advisable to take a sample cut on
a scrap piece of lumber. This will show you
exactly how the cut will look as well as enable
you to check dimensions. Position the fence
so that the work piece feeds against the
cutter rotation.
ELECTRICAL SAFETY
!
To reduce the risk of injury, avoid “climb
cutting.” Climb cutting can cause the
work piece to be thrown violently out of
your control. Even small router bits can
cause in climb cutting.
13