Carat P-7010, Operating Instructions Manual

Page: 51 / 52

51
GB
In the event of scrapping the entire machine, it must
be disposed of in accordance with the methods laid
down by current legislation.
Electric Motor
Aluminium AL
Steel AC
Copper CU
Polyamide PA
Main Casing
Steel AC
Polyamide PA
Aluminium AL
Submerged Pump
Polyamide PA
Steel AC
Aluminium AL
Copper CU
Epoxy Resin
W.E.E.E. IT08020000002803
The European Directive 2002/96/CE
arranges that in the event of scrapping of
electrical equipment, they must not be
disposed of city solid refusals but collected
separately, in order to optimize the level of recovery
and recycling of the materials and above all in order
to prevent damages to health and environment.
To comply with European Directive 2002/96/CE, all
electrical equipments must be marked with crossed
basket symbol. The packing of the machine will be
disposed of in accordance with the methods laid
down by current legislation. For further information
concerning disposal of electrical equipment, please
refer to public administration service.
THIS TOOL MUST ONLY BE REPAIRED BY TRAINED PERSONNEL
This electric tool complies with the relevant safety standards. Repairs are only to be carried out by
trained personnel, using original spare parts. Where this is not done, the user may be placed in
significant danger.
Problem
The machine does not run
Lubrication does not reach the
cutting tool.
The motor emits unpleasant
smells.
The motor does not start properly.
The laser marker does not work.
Cause
The power supply cable is not
properly connected or damaged.
There is no power at the socket.
The motor high temperature trip
switch has tripped.
The high temperature trip switch
is damaged.
The control switch is damaged.
The sprayer unit is clogged.
The circulation pump is
damaged.
The lubrication hose is being
flattened.
Water has filtered into the motor.
The motor's bearings are
damaged.
The laser unit is damaged.
The marker feeder is damaged.
Solution
Push the plug all the way in.
Check the power supply cable.
Have the power supply socket
checked.
Wait a few minutes for the motor
to cool down.
Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
Remove the sprayer inside the
disc cover and clean any deposits
off of it.
Contact your local dealer for a
replacement.
Eliminate any kinks in the
lubrication hose.
Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
Contact your local dealer for a
replacement.
13. Disposal
14. Troubleshooting