Carat P-7010, Operating Instructions Manual

Page: 45 / 52

45
GB
N.B. To ensure correct functioning, periodically
check the effi
ciency of RCCBs by pressing the
push-button on the front of the device.
- Make sure that the section of the power supply
cable cores has been measured according to
the starting current and its length.
For cables up to 50 m long, a section of 4 mm
2
is enough.
- Before connecting the machine to the power
socket, check that the power supply voltage
corresponds to that shown on the plate on the
machine.
- The machine must be connected to an eff ective
earth wire.
In case of doubt, do not connect the machine.
CONTROL DEVICES
CAUTION!
The P-7010 machine is equipped with a control
board made up of:
1) START BUTTON: (BLACK COLOUR)
Press the button fully to activate machine
starting.
2) REGULAR STOP BUTTON: (RED COLOUR)
Press the button fully to activate machine stop.
The device has an interlocking system.
Before starting the machine, make sure that the
device is in release position.
Turn it 90° clockwise to unblock it.
3) DEVICE FOR DISCONNECTION FROM THE
MAINS (Plug):
Machine power supply point.
Use an extension with a 5-pole socket.
During the maintenance phases, take out the
plug from the device in order to disconnect the
machine from the mains.
4) LASER MARKER
It projects the cutting line on the table.
It is enabled when the machine is connected to
the mains.
CAUTION!
Before using the machine, check there is power
supply.
BLADE ASSEMBLY / DISASSEMBLY
Before performing any operation or adjustment,
disconnect the machine from the supply mains.
Unscrew the knobs and the locking nut on the disc
cover and remove it.
Remove the blade fi xing nut using the 30 mm
spanner and the 5 mm Allen wrench.
16
CAUTION!
IN ADDITION TO THE KNOBS ALWAYS
REASSEMBLE THE LOCKING NUT ON THE
DISC COVER.
CAUTION!
THE BLADE FIXING NUT HAS A LEFT-HAND
THREAD.
• Install the new blade, checking for correct
direction of rotation as clearly indicated on the
tool.
• Tighten the blade and put the blade cover guard
back in position.
CONNECTING TO POWER SUPPLY
CAUTION!
The machine is to be connected to the power
supply by a residual current circuit breaker (RCCB)
with the following characteristics:
RCCB In 16 A Id 30 mA