Carat P-7010, Operating Instructions Manual

Page: 46 / 52

46
GB
19
CUTTING UP TO LENGTH OF:
• 795 mm P-7010
By adjusting the cut start and end carriage
stoppers, the entire stroke available for the cutting
head carriage can be used and longer cuts can be
obtained.
Model P-7010
1) With a 5 mm Allen wrench, loosen the cut start
carriage stopper.
(see picture 20)
20
2) Put the carriage stopper in the new position
B indicated on the label and lock it again
(see pictures 20 and 21).
3) Fold up the additional splash guard.
(see picture 14)
17
8. Cutting on the table
CAUTION!
BEFORE STARTING THE CUTTING
OPERATIONS, THE OPERATOR MUST MAKE
SURE THAT AT LEAST 150 cm ARE LEFT FREE
AROUND THE MACHINE (See picture 18).
IN ORDER TO WORK IN SAFETY CONDITIONS,
DO NOT LET OTHER PEOPLE REMAIN
NEAR THE MACHINE DURING THE CUTTING
OPERATIONS.
1
2
1.5m
1.5m
1.5m
18
- Arrange the piece to be cut on the working table
at the desired measurement (see picture 19);
CAUTION!
BEFORE PERFORMING THE CUTTING
OPERATIONS, MAKE SURE THAT THE
MATERIAL IS PROPERLY LEANED AGAINST
THE TILE STOPPER.
- Start the machine and wait until cutting
blade cooling water comes out, adjusting the
necessary amount by means of the water on-
off valve located on the blade guard, and cut
(see picture 19).