CTR9 Car-O-Liner
Group
AB
49023, EN - rev. 4,
2020-01
41
3.13.1 Working with the C-Tong hanging from the support arm
WARNING!
Please note, that the support arm is designed only for a limited
sideways rotation angle (fig 1). Do not exceed this angle by pulling the
hanging C-Tong sideways. The welder might tip, causing personal injuries
or material damage.
WARNING!
Please note, that the support arm is designed only for a limited
lengthwise range of 45
°
from vertical (fig 2). Do not exceed this angle.
When the balancer suspension rope is fully extended, do not pull the hanging
C-Tong any further. The welder might tip, causing personal injuries or
material damage.
WARNING!
To avoid the risk of the welder tipping when using the support
arm, always work within the allowed range as described above.
If you need to reach further, move the machine.
See section 3.12.2 Moving
the machine with support arm.
WARNING!
When working with the C-Tong hanging from the support arm,
always make sure that the wheels are unblocked. Otherwise the welder might
tip, causing personal injuries or material damage.
Fig 2. The position of the C-Tong shall not exceed the
limited lengthwise range of 45° from vertical!
Fig 1. The position of the C-Tong shall not exceed the
limited sideways rotation angle!
