Version 08.05.2019
MIB-Entry-5inch (180514)
CI-RL5-MIB2-E
P
a
g
e
19
2.6.
After-market rear-view camera:
To switch the interface’s rear-view camera input, an external switching signal from the
reverse gear light is required. As the reverse gear light signal contains electronic
interference, a traditional open relay (e.g AC-RW-1230 with wiring AC-RS5) or filter (e.g. AC-
PNF-RVC) is required. Below schema shows the use of a relay (normally open).
Connect the single green colored wire and the rear-view camera’s power both to the relay’s
terminal (
87
).
Connect the reverse light’s power to the relay’s coil terminal (
85
).
Connect permanent power to the relay’s input terminal (
30
).
Connect vehicle’s ground to the relay’s coil terminal (
86
).
