C 1308 / BW-E160010
C.
INTRODUCTION
D.
DESCRIPTION OF THE BATTERY CHARGER
This charger can charge 4 kinds of batteries Ni-CdNi-MH, RAM &Alkaline. Accommodates both AA, AAA, C, D size and 9V
batteries.
The Four separate battery charging bays function independently
This enables charging of up to 4 batteries simultaneously.
Note : Batteries must of the same type is Ni-Cd
、
、
、
、
Ni-MH or alkaline.
Battery type is preselected therefore only one type (Ni-Cd, Ni-MH, RAM or alkaline (Ram Setting)) battery can be charged at
one time.
This charger uses the latest battery charging technology. It uses “-delta V” deletion when charging Ni-Cd &Ni-MH battery
first, followed by a quick charge. Once the battery is fully charged, a constant current trickle charge will keep the battery at
optimum capacity.
As 2 USB port to recharge smartphone and tablets.
Discharging Ni-Cd only: Discharge times will very dependant on capacity and charge state, typically the process could take
up to one hour, before the charge cycle commences.
During the discharge process The indicator LED will glow amber.
IMPORTANT NOTE REGARDING THE RECHARGING OF ALKALINE BATTERIES:
This charger can charge and extend the life of most new and high quality alkaline batteries.
Be sure to set the switch (7) to
"ALK" (leftmost position when facing the charger).
Most high-quality alkaline batteries can be recharged up to ten times, allowing them to hold about 75 to 90% of their
power, until the batteries run out. These batteries should not be completely drained before recharging.
For safe and optimal performance, please follow the instructions in this manual.
E.
HOW TO USE IT
₋
Connect the DC plug from the AC adaptor to the DC socket on the rear of the charger.
₋
Insert the AC adaptor into the household supply ensuring the wall socket is switched ON. This will cause the LED
power indicator light (10) to turn on.
₋
Select the required battery type by moving the selection switch (7) between Ni-Cd
,Ni-MH or ALK batteries (Switch must not be moved after batteries are loaded).
₋
Insert the required number of batteries into the charger, making sure the correct
polarity is observed (+ is uppermost)
₋
After approximately 2 seconds the Charger will automatically detect the status of the battery.
₋
Once battery detection is complete one of the following charging programs will start.
₋
The charger automatically begins to charge your batteries, as indicated by both LED and LCD Status Indicators.
1.
- pole
2.
Battery compartment
3.
+ pole
4.
LED light for 9V battery
5.
LED light for other battery
compartments
6.
USB 1A
7.
Battery selection switch
8.
USB 2A
9.
LCD screen
10.
Power LED light
11.
DC socket
12.
9V battery compartment
