7.2 ADJUSTING THE COFFEE STRENGTH
To increase the strength of the coffee we recommend programming a higher cup
amount such as 10 or 12 cups then reducing the amount of water you add to the
water tank. For example, select 12 in the CUPS setting but only fill the water tank
to the 8 cup marking. This will add extra ground coffee to the filter and increase the
strength of the brew.
7.3 POWER INTERRUPTION
• If the machine is unplugged or power is interrupted all settings described in
chapters 7.1 and 7.2 must be reset.
• If the machine was set to Auto-On and power was interrupted, the machine
will not brew coffee at the programmed time.
7.4 REMOVING / ATTACHING THE BEAN CONTAINER
• Grasp the bean container with two hands and turn the bean container clockwise.
• Once the bean container is unlocked, lift straight up off of the machine. The door
on the bottom of the bean container will keep any beans from falling out of the
bottom of the bean container.
• To remove and replace the upper burr see chapter 7.5 below.
• Place the bean container back onto the machine at a slight angle and match the
"Align" icon on the left of the machine to the "Align" icon on the left of the bean
container (Fig.7) and turn the bean container counterclockwise to lock back into
position.
IMPORTANT:
Follow cleaning instructions in chapter 10.4 - 10.6 for bean container
and coffee chute maintenance.
NOTE:
If the bean container is not locked back into place when the BREW button
is pressed, the machine will beep indicating there is an error, correctly align and
lock the bean container.
7.5 REMOVING / REPLACING THE UPPER BURR
• Follow steps above in chapter 7.4 to remove the bean container.
• Turn the fineness knob clockwise towards RELEASE to unlock the upper burr.
• Pull the upper burr straight out using the small metal handle attached to the
upper burr (Fig. 8).
IMPORTANT:
Never try to remove the lower burr!
NOTE:
Clean the upper burr regularly as described in chapter 10.7
• To reassemble, place the upper burr back into the machine and ensure it is
correctly placed as seen in Fig. 8 & Fig. 9. If the upper burr does not fit correctly,
adjust it until the upper burr sits flush in the machine.
IMPORTANT:
Push metal upper burr handle to the left or right side prior to
attaching the bean container.
• Turn the fineness knob counterclockwise to Coarse, Medium or Fine to lock
the upper burr in place.
IMPORTANT:
Never run the machine with the upper burr unlocked (fineness knob
in RELEASE position). Always double check the upper burr is locked back in
place when reattaching the bean container.
• Attached the bean container as described in chapter 7.4
IMPORTANT:
If the grinder seems to be clogged, always run a "Grind & Clean
Cycle" and then clean the ground coffee chute before attempting to remove the
upper burr. (See chapters 10.5 to 10.7).
10
