7.6 GRINDER SETTINGS / FILLING THE BEANS
• Select the fineness setting (Fig. 4) by turning the knob until the indicator
matches up with one of the fineness levels in front of the bean container from
fine to coarse.
• For first time use, use the coarsest setting.
• For dark oily beans use a coarse setting and push the OILY button until the
oily bean icon illuminates to select the oily bean function. For light, dry beans
use the finer settings.
• Open the bean container lid (Fig. 1.8) and fill the bean container (Fig. 1.7) with
whole coffee beans. Make sure that the water container lid is closed to prevent
beans from spilling into the water container.
CAUTION:
Check beans for foreign objects (chapter 3e).
• The bean container will hold approximately 8-oz of beans.
IMPORTANT:
Never fill the bean container with frozen or coated beans
(chapters 3a and 3d).
NOTE:
If the bean container lid is not in place when the BREW button is
pressed, the machine will beep indicating there is an error. Push down on the
lid to fully engage the lid.
7.7 FILLING THE WATER CONTAINER
• Grasp the back section of the water tank and pull the water tank straight up.
• Open the water container lid (Fig. 1.11) and fill the water container with the
desired amount of fresh, cold water. Follow the 2 – 12 cup markings on the side
of the water container and fill to the corresponding cups you programmed in
the CUPS setting.
CAUTION:
Never fill water above the 12-cup marking!
NOTE:
See chapter 7.2 to increase strength
7.8 CHARCOAL WATER FILTRATION
CoffeeTEAM PRO Plus comes with one charcoal cartridge and a charcoal filter
holder. You can brew coffee with or without the water filtration system.
NOTE:
If you use distilled, spring or bottled water or if your water has little or
no chlorine you may not find a difference in taste in your coffee when using the
water filtration system. However, most tap water is treated with chlorine. The
water filter cartridge removes up to 82% of the chlorine found in your tap water.
Initial Preparation:
• Open the water container lid and remove the charcoal filter holder.
• Remove the charcoal filter from polybag.
• Soak the filter in a glass with cold water for a few minutes. This will activate
the filter.
• Insert the cartridge into the charcoal filter holder (Fig. 12) and snap charcoal
filter holder closed.
• Place the charcoal filter holder back into the water tank and ensure it is fitted
tightly above the valve.
When to replace the cartridge:
• Replace the filter after 60 pots of coffee or 6 weeks after first use, whichever
comes first. Unused cartridges can be stored indefinitely.
• Replacement cartridges are available through your local Capresso dealer or
through the website: www.capresso.com.
11
