23/27
1. Power - N 2. Compressor
3. Power - L 4. fan
5. LED light 6. Display PCB 7. Sensors and door switch
6.2.3
．
How to remove the compressor
The process: Remove the electrical cover of compressor
→
disconnect the connectors
→
separate the pipe connect to the compressor
→
remove the compressor
Heat E, F with soldering iron, and disconnect the pipes by using the pliers. Remove the
electrical cover of the compressor, and then remove four compressor fixing screws, remove
the compressor.
(Fig.17)
Diagram of rear soldering joints
(Fig.17)
A: Jointing pipe and condenser joint B: Process pipe joint C: Electrical cover of compressor
D: Compressor
E: Suction pipe joint F: Discharge pipe joint
G: Capillary joint
H: Condenser and filter joint I: Outer water tank support
J
：
Four condenser fixing screws K: Condenser and filter joint
6.2.4
．
How to remove the outer condenser:
Process of removing the outer condenser: Remove four fixing screws
→
Remove the outer
condenser
Separate on A, H by Soldering iron for copper pipes, separate the pipe using the pliers,
remove four screws J, remove the condenser K.
(Fig.17)
A
B
C
E
F
G
H
J
K
Fig.17
I
D
