Instruction manual C871GBK
Please keep this instruction manual for future reference
14
- The room must also allow for the influx of the air needed for proper combustion. The flow of air
for combustion purposes must, not be less than 2 m³/h per kW of installed capacity. The supply of
said air can be effected by means of direct influx from the outside through a duct with an inner
cross section of at least 100cm² which must not be able to be accidentally blocked.
- Intensive and prolonged use of the appliance may necessitate supplemental ventilation, e.g.
opening a Window or increasing the power of the air extraction system.
GAS HOB INSTALLATION
The gas hobs are prepared with protection degree against excessive heating of type X, the
appliance can therefore be installed next to cabinets, provided the height does not exceed that of
the hob. For a correct installation of the cooking hob the following precautions must be followed:
- The hob may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom
or shower room.
- The furniture standing next to the hob, that is higher than the worktop, must be placed at least
110mm from the edge of the hob.
- The cabinets positioned next to the hood should be at a height of at least 420 mm (Fig. 5).
-
You must have a gap of at least 25mm bewteen the underside of the hob and any surface that is
directly below it.
Fig. 5
Fig. 6
Fig.5 Fig.6
d)
Should the hob be installed directly under a cupboard, the cupboard should be at least 700mm from the
worktop, as shown in Fig.5.
e)
The cut out dimensions for the worktop must be those indicated in the figures shown below. Fixing hooks
are provided which allow place the hob plate on work tops that measure 20 to 40 mm in thickness (see
Fig. 6).To obtain a of the hob plate it is advisable to use all the fixing supplied.
Fig.6
Hook position for Hook position for Hook position for
H=30mm
top
H=40mm
top
H=20mm
top
N.B:
Use the hook contained in the "accessories set"
In the event the hob is not installed above a built-in oven, a wood panel must be inserted as insulation.
This panel must be placed at least 20 mm from the bottom of the hob itself.
Important:
When installing the hob above a built-in oven, the oven should be placed on two wooden strips;
in the case of a joining cabinet surface, remember to leave a space of at least 45 x 560 mm at the back.
C871GBK - Instruction Manual.indd 14
12/04/2019 13:57
