19
INSTALLATION INSTRUCTIONS
The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforced in their country.
How to stick the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
Installation has to be done carefully, in conformity with the following drawing.
Fitting - installing:
•
The cut-out sizes and flush mounting:
Glass
Cut size
Rear
Side
Radius
Cut size
Deep
A1
B1
C
D
E
F
H
A2
B2
G
520
780
490
560
50
40
8
526
786
5
•
Ensure that there is a distance of 50mm between the hob and the wall or sides.
•
The hobs are classified as “Y” class for heat protection. Ideally the hob should be
installed with plenty of space on either side. There may be a wall at the rear and tall units
or a wall at one side.
On the other side, however, no unit or divider must stand
higher than the hob.
•
The piece of furniture or the support in which the hob is to be fitted, as well as the edges
of furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100°C.
•
The mural rods of edge must be heat-resisting.
•
Not to install the hob to the top of a not ventilated oven or a dishwasher.
•
There must be
a space of 20mm
beneath the bottom of the hob casing to ensure a good
air circulation of the electronic device. (See page 20 for full ventilation information)
•
If a drawer is placed under the worktop, avoid placing flammable objects (for example:
sprays) or not heat-resistant objects inside.
•
Materials which are often used to make worktops, expand on contact with water. To
protect the cut-out edge, apply a coat of varnish or special sealant. Particular care must
be given to applying the adhesive joint supplied with the hob to prevent any leakage into
the supporting furniture. This gasket guaranties a correct seal when used in conjunction
with smooth work top surfaces.
Stick the gasket (2) two millimeters
from the external edge of the glass,
after removing the protection sheet (3).
