10
step 4: installing anti-tip device (cont.)
IMPORTANT INSTALLATION INFORMATION:
1) The Anti-Tip Bracket may be attached to a solid wood
cabinet having a minimum wall thickness of 3/4”.
2) The thickness of the wall or floor may require use of
longer screws, available at your local hardware store.
3) In all cases at least two (2) of the bracket mounting
screws must be fastened to solid wood or metal.
4) Use appropriate anchors when fastening the mounting
bracket to any material other than hardwood or metal.
Prepare holes at fastener locations as
identified below:
• FOR WALLS, WALL STUDS, OR FLOORS
COMPOSED OF SOLID WOOD OR METAL,
DRILL 1/8” PILOT HOLES.
• FOR WALLS OR FLOORS COMPOSED OF
DRYWALL, SHEET ROCK, OR OTHER SOFT
MATERIALS, DRILL 3/16” HOLES TO A MINIMUM
OF 1-3/4”, THEN TAP PLASTIC ANCHORS INTO
EACH OF THE HOLES USING A HAMMER.
• FOR WALLS OR FLOORS COMPOSED OF
CONCRETE OR CONCRETE BLOCK, DRILL 3/16”
HOLES TO A MINIMUM DEPTH OF 1-3/4”, THEN
TAP CONCRETE ANCHORS INTO EACH OF THE
HOLES USING A HAMMER.
• FOR WALLS OR FLOORS HAVING CERAMIC TILE
COVERING, DRILL 3/16” HOLES THROUGH THE TILE
ONLY, THEN DRILL INTO THE MATERIAL BEHIND
THE TILE AS INDICATED IMMEDIATELY ABOVE.
MOUNTING ANTI-TIP BRACKET:
The alternative floor mounted bracket shall be
installed as follows:
1) Place bracket on floor in position shown
(Fig. 6)
,
2) Secure to floor or wall stud.
3) Later, when unit is installed, the adjustable leg
will slide under the bracket.
B.
C.
Fig. 6
