c)
Remove the 2 screws at the base of the control panel. The base of the
burner unit can now be lifted, lift the two retaining tabs on the burner
brackets from the back of the firebox, allowing the burner to be
removed. See fig. 5 below
Fig. 5
d)
Refer to the fitting instructions for the hearth panel and casting and fit to
the builders opening as prepared to the dimensions stated in section 1.6
e)
With the hearth panel and casting in position, ensure that the hearth is
protected from damage.
f)
Mark out and drill 4 off No 14 (6mm) holes in the back face of the fire
opening in the positions shown overpage in fig. 6
12
Burner Engine
Burner Heat Shield
Firebox
Flue restrictor baffle - held in
position by 2 off screws - only to
be left in position when fitted to
class 1 flues
2 off screws
