5. Once the desired height is selected and the tank pod secured on top of the hatchway, turn the
two adjustment knobs (A) on the main body toward the center section. This will stabilize the
unit during use.
Note:
It is not always possible that you will not be able to achieve the
desired height when position is a factor as well.
6. To secure the winch-mounting bracket, remove the two 3” pins (H) and one 4” pin (E) from
the bracket. Place the bracket over the back leg on the main body and replace the two 3” pins
(H) behind the leg. Once secured, replace the 4” pin through an open hole on the leg tube. If
no open hole is present, remove the positive lock pin partially back and push the 4” pin (E)
through the that same hole. Completely remove the positive lock pin and push the 4” pin (E)
completely through.
7. Secure the winch-mounting bracket on the tank pod bracket by removing the two 3/8” pins
and placing it over the tank pod bracket and replacing the pin in the available holes.
8. Mount the winch or SRL in accordance to the operator’s manual.
9. Remove the top two 3/8” pins (F) on the main body and place your cable over the rollers.
Replace your pins to assure the cable does jump the path during use.
10. The anchor point (G) located on a front side of the main body is an approved anchorage
point for secondary lifelines such as rope drops and retractables.
Page 19
