OPERATING SAFETY
1. Read, understand and follow the User
Manual and signs on the equipment before
using, maintaining or inspecting the
equipment.
2. Train all operators before allowing them to
use the equipment. An untrained operator
exposes themselves, bystanders and
workers to possible serious injury or death.
3. Visually inspect the equipment and all
auxiliary components and equipment before
using. Correct any problems before using
the equipment.
4. Securely anchor the winch before using.
5. Use only certified anchor and connector
components in your system.
6. All anchor points, or mounting/setup
locations for permanent or portable systems
must be approved to local standards by a
qualified engineer.
7. Use only an approved body harness for the
workers.
8. Always work in teams. One person works in
the confined space and the other one pays
out the line and reels it in.
9. Do not use the equipment when the winch
brake wear indicators display in the red or
the counter exceeds 30,000 cycles. Return
equipment to manufacturer for service.
10. Do not exceed 450lbs. (205 kg) on the line
during operation
11. Use only retractable lifelines or shock
absorber with a maximum arrest force
(MAF) equal to or lower than the lowest
rated component of your system.
12. Establish a regular training program for
new and experienced workers.
13. Establish a detailed inspection program for
your equipment and document the findings.
Return the equipment to the manufacturer
for rework if any problems are found.
14. Plan your work program before starting.
Have the required people, equipment and
procedures available to do the job.
15. Do not use the equipment around physical
or environmental hazards. This list
includes but is not limited to:
a. Corrosion that may affect the structural
integrity of the life line or other
components .
b. Chemicals which can degrade
components and not be visible.
c. Toxic gases: Rescuers or workers can
be killed in toxic environments.
d. Heat or elevated temperatures.
e. Moving machinery: Workers or
auxiliary equipment can be contacted
by or pulled into moving components.
f. Sharp edges: Workers or the rescue
equipment can be injured by or
damaged by sharp edges or
components.
g. Electrical hazards: Stay away from
power lines or components carrying
electrical power.
h. Overload: Do not exceed 450 lbs. (205
kg) during operation.
i. Follow confined space regulations in
Standards.
Page 16
