CAPINTEC, INC.
CRC
®
-712MH
The following equipment should be found upon unpacking the optional Printer carton:
•
Power Supply (If Roll printer ordered)
•
Printer
Ribbon
•
Communications
Cable
•
Roll Paper (If Roll printer ordered)
Note: If Test Sources are ordered, they will be shipped separately.
ASSEMBLY
1. Verify that that the power switches for the Readout Unit and the printer are in the
“OFF” or “0” position.
2. Connect the Chamber Cable(s) to the connector(s) at the rear of the CRC
®
-712MH
Readout labeled “IONIZATION CHAMBER”.
3. Attach the printer cable to the “PRINTER” Port connector at the rear of the CRC
®
-
712MH Readout. Attach the other end to the Epson or Okidata printer.
4. For each printer type, verify that the correct paper is installed.
5. Attach the Power Cables to the Power Entry Module located on the back of the
Readout Unit and to the printer (or power pack).
Figure 4-1 Printers
4 - 2
SYSTEM SETUP
January 08
