Capetti Elettronica WineCap WSD15IIDIST, User Manual

Page: 6 / 10

WSD15IIDIST
User Manual
CAPETTI ELETTRONICA s.r.l. - Strada Stratta, 57
10090 CASTIGLIONE TORINESE - TORINO - ITALY
VAT 04837130014 - Phone 011.981.98.11 - Fax 011.981.98.210
e-mail
info@capetti.it - web www.capetti.it
WA0416E_WSD15IIDIST_User Manual_R05
V5.0
8. Enrolling the device.
Not necessary if performed in factory before delivery.
Enroll the device to the network referring to the “ WineCap System - User Manual R30 ”. In case the device is already enrolled but in
STANDBY status, a TEST command must be issued (
refer to Picture 3 - Commands table
).
9. Installation procedure.
After installing the basestation in appropriate place in charge, (
refer to “ WineCap System - User Manual R30 ”
), be sure that the device is
enrolled to the basestation and activated.
Head for the environment to be monitored. On the way, to check the quality of the radio coverage, use the " Field Measurer " function.
This function is activated issuing the TEST (
refer to Picture 3 - Commands table
)command: position the WineCapKey in the spot indicated
in Picture 2 - WineCapKey positioning and wait for two AMBER flashes, then remove the WineCapKey from device. The " Field
Measurer " function lasts enabled for two minutes.
To issue commands to the device, place the WineCapKey where indicated.
Once the WineCapKey is detected, the led periodically emits AMBER flashes with a 2 second cadence.
For each flash, a different command is associated; to confirm the command the WineCapKey must be removed from the sensible
area immediately after the number of flashes corresponding at the desired command. The TEST corresponds to the second pulse and
activate the " Field Measurer " function.
The device will give back the radio signal quality through led flashes:
WIRELESS MODE STATUS Table
Flash count - Wireless mode Status/Radio signal quality
5 green flashes Excellent
4 green flashes Good
3 green flashes Fair
2 amber flashes Sufficient
1 red flash Insufficient
1 red flash 2” long
OUT OF RANGE
Network searching
2 red flashes 2” long STANDBY
Short-long-short red
flashes series
FACTORY RESET
Device not enrolled
Optimize reception selecting the best position: small movements can help.
If the signal is absent or insufficient at the install point, a WR12 repeater should be put between (
refer to “ WineCap System - User Manual
R30 ”
). The WR12 repeater itself must be in a position where the signal level is at least sufficient.
The network will reconfigure itself automatically; the signal will be good again when the device synchronizes with the WR12 repeater .
The link will not be reconfigured until completely lost by the device. Because of this, in some cases it could be necessary to force the
operation. In such cases, put the device in
STANDBY mode, then run the TEST again (
refer to “ WineCap System - User Manual R30 ”
).
NOTE : The display equipped datalogger (
WD04T
) is recommended, to verify the signal quality during devices installation.
Picture 4 - Status table - Radio signal quality