background image

4

Model no. 085-1271-6

•  Pay attention when operating the fireplace. It is hot when in use and should never be left unattended. Do 

not move it while in operation.

•  Do not use this fireplace for cooking.
•  Do not put any other fireplace cover or anything flammable on, beneath, or around the fireplace.
•  Users should be alerted to the hazards of high surface temperatures and keep a safe distance to avoid 

burning or clothing ignition.

•  Do not sit on the fireplace. Do not rest feet or hands on the fireplace.
•  Never lean over the open fireplace or place hands or fingers on the upper portion of an operational unit.
•  Keep any electrical supply cords and the fuel supply hose away from any heated surfaces.
•  Combustible materials should never be within 6’ (1.8 m) of the top, or within 4’ (1.2 m) of the back or sides of 

the fireplace.

•  This fireplace must be attended at all times!
•  Should the fire go out while burning, turn the gas valve off. Follow the instructions, and wait five minutes 

before attempting to relight.

•  Do not use this fireplace if any part has been under water.
•  Do not pour water into fireplace.
•  Immediately call a qualified service technician to inspect the appliance and to replace any part of the 

control system and any gas control which has been under water.

•  Do not light or use gas unit if lava rocks are wet. Ensure lava rocks are completely dry before igniting as 

intense heat could cause the rocks to crack or pop.

•  Do not attempt to disconnect the gas regulator or any gas fittings while your fireplace is in operation.
•  Do not handle fireplace until it is shut off and completely cooled.
•  The propane gas tank must be disconnected when fireplace is not in use.
•  Do not store a spare or disconnected propane gas tank under or near this fireplace, or in the vicinity of any 

other appliance.

•  If the fireplace is stored indoors, detach and leave propane gas tank outdoors.
•  Do not enlarge valve orifices or burner ports when cleaning the valve or burner.
•  Do not use this fireplace on vehicles or boats. Always operate the appliance on flat ground outdoors.
•  After a period of storage and/or non-use, the propane fireplace should be checked for gas leaks and burner 

obstructions before use.

•  The propane fireplace should never be used by children. Children must be supervised when they are 

anywhere near the appliance.

•  Please keep gas tank a minimum of 9’ (2.7 m) away from fireplace when lit.
•  The maximum gas supply pressure is 250 PSI.
•  Clothing or other flammable materials should not be hung from the appliance, or placed on or near the 

appliance.

•  Any guard or other protective device removed for servicing the appliance must be replaced prior to 

operating the appliance.

•  All installation and repair should be done by a qualified service person. This appliance should be 

inspected annually. More frequent cleaning may be required as necessary. It is imperative that the control 

compartment, burners and circulating air passageways of the appliance be kept clean.

•  Inspect the burner before each use of this fireplace. If there is evidence of damage, the burner must be 

replaced prior to use of this fireplace.

•  Inspect the hose before each use of this fireplace. If the hose shows signs of cracks, abrasion, cuts or 

damage, do not use this fireplace. Fix the hose as required before using appliace.

•  Remove the hose out of pathways where it may be tripped over or subject to accidental damage.
•  Children and adults should be alerted to the hazards of high surface temperatures and should stay away to 

avoid burns or clothing ignition.

•  Young children should be carefully supervised when they are in the area of this appliance.
•  The LP gas supply tank must be constructed and marked in accordance with the specifications for LP gas 

tanks of the U.S. Department of Transportation (DOT) or the National Standard of Canada CAN/CSA-B339, 

LP gas tanks, spheres and tubes for the Transportation of Dangerous Goods; and Commission.

•  The LP gas tank must have a listed overfill prevention device (OPD) and a QCCI or Type I, (CGA810) LP gas 

tank connection.

IM

P

O

R

TA

N

T S

A

FE

T

Y

 IN

ST

R

UC

TI

O

N

S

Summary of Contents for 085-1271-6 RICHMOND

















Reviews: