17
GB
Inspection before starting
1. The power cord must not be damaged or split.
2. Before use, please verify that the power socket meets the current rating requirements in
the table above and is correctly earthed. If not, the socket must be replaced.
Turning on and power selection
1. Turning on
Plug the power cord into the power socket, turn the thermostat knob clockwise to the " "
position, then turn on the power switch, and the heater should start to work.
2. Power setting
Under normal circumstances, use the maximum power setting "3" for rapid heating. If the
room temperature reaches a suitable temperature, reduce the setting to "2" or "1" to reduce
energy consumption and prevent the room from becoming overheated.
Note!
When using the heater for the first time or using a different power sock-
et, check that the plug fits well in the socket.
Inspection method
Insert the power plug into the power socket and turn the heater on; after about half an hour,
turn it off and pull out the plug. Check whether the plug pins are hot; replace the socket if so
(more than about 50°C) to avoid burning the plug or even causing a fire through overhea-
ting of the socket due to poor contact.
Temperature adjustment
During use, if you feel it is necessary to lower the room temperature, adjust the heat setting
as follows:
1. Turn the power switch to setting "2" or "1".
2. Turn the thermostat knob anticlockwise so that the temperature indicator is closer to the
" " position.
Turning off
Turn the power switch to the "0" setting, then unplug the power cord from the power socket .
Moving the heater
To move the heater, turn it off first, unplug it from the power socket, then push the heater
body so that it rolls on the four castors.
OPERATING INSTRUCTIONS
