17
© 2021, Elon Group AB. All rights reserved.
OPERATING INSTRUCTIONS
INSPECTION BEFORE STARTING
1.
The power cord must not be damaged or split.
2.
Before use, please verify that the power socket meets the current rating
requirements in the table above and is correctly earthed. If not, the socket
must be replaced.
TURNING ON AND POWER SELECTION
1.
Turning on. Plug the power cord into the power socket, turn the thermostat
knob clockwise to the ” ” position, then turn on the power switch, and the
heater should start to work.
2.
Power setting. Under normal circumstances, use the maximum power
setting ”3” for rapid heating. If the room temperature reaches a suitable
temperature, reduce the setting to ”2” or ”1” to reduce energy consumption
and prevent the room from becoming overheated.
NOTE! When using the heater for the first time or using a different
power socket, check that the plug fits well in the socket.
INSPECTION METHOD
Insert the power plug into the power socket and turn the heater on; after about
half an hour, turn it off and pull out the plug. Check whether the plug pins are
hot; replace the socket if so (more than about 50°C) to avoid burning the plug
or even causing a fire through overheating of the socket due to poor contact.
TEMPERATURE ADJUSTMENT
During use, if you feel it is necessary to lower the room temperature, adjust
the heat setting as follows:
1.
Turn the power switch to setting ”2” or ”1”.
2.
Turn the thermostat knob anticlockwise so that the temperature indicator
is closer to the ” ” position.
TURNING OFF
Turn the power switch to the ”0” setting, then unplug the power cord from
the power socket .
MOVING THE HEATER
To move the heater, turn it off first, unplug it from the power socket, then
push the heater body so that it rolls on the four castors.
Summary of Contents for COE3200V
Page 52: ......
