1.
Mark the positions for four expansion bolts
based on dimensions in the Unit Mounting
Dimensions chart.
2. Pre-drill holes for expansion bolts.
3. Clean concrete dust away from holes.
4. Place a nut on the end of each expansion bolt.
5. Hammer expansion bolts into the pre-drilled
holes.
6. Remove the nuts from expansion bolts, and
place outdoor unit on bolts.
7. Put washer on each expansion bolt, then
replace the nuts.
8. Using a wrench, tighten each nut until snug.
9. Think about the snow depth, the outdoor sec-
tion must be placed at a height that ensures
that snow can not cover it.
OUTDOOR UNIT INSTALLATION
Outdoor Unit Dimensions (mm)
W x H x D
Mounting Dimensions
Distance A (mm)
Distance B (mm)
800x554x333 (31.5”x21.8”x13.1”)
514 (20.24”)
340 (13.39”)
If you will install the unit on the ground or on a concrete mounting platform
landing stand must be used,
do the following:
WHEN DRILLING INTO CONCRETE, EYE PROTECTION
IS RECOMMENDED AT ALL TIMES.
WARNING!
56
© 2021, Elon Group AB. All rights reserved.
EN
Summary of Contents for 20-046
Page 174: ......
