Canton Smart Vento 9, Operating Instructions Manual

Page: 74 / 106

76
English
LIP (Lip Sync)
The LIP function allows you to take corrective action when the sound is not lip-sychronous with the pictures on your TV�
For this, proceed as follows:
1
Select the SYS menu as described in the chapter SYS (System Setup) and select the SSM function using the navigation button “ ” and “ ”.
2
The “+/–” buttons can now be used to delay the sound playback in steps of 10 ms to adjust the sound to the “delayed” image�
The maximum possible delay is 80 ms�
VOL (System Volume)
With the VOL function you can limit the maximum value of the volume, displayed in the speaker's display to a value below the maximum of “99”�
For this, proceed as follows:
1
Select the SYS menu as described in the chapter SYS (System Setup) and select the VOL function using the navigation buttons “ ” and “ ”.
2
With the “+/–” buttons you can now adjust the maximum volume�
ASM (Analog Stereo Mode)
By default, both channels of the analog source device are connected to the right and left analog line inputs of the master speaker
and the signals are transmitted to the slave speakers via radio depending on the selected playback mode and the number of coupled speakers�
If the ASM function is set to DST (Dual Stereo), the signal will no longer be transmitted by radio, but the source device must be connected
directly to the analog line input of the corresponding speaker� For example, from a source device, the left channel must be connected the left
Analog Line input of the left speaker and the right channel of the source device must be connected to the right Analog Line input of the right
speaker� If, in the case of a multi-channel setup, all speakers are connected directly to a multi-channel preamplifier or the preamplifier outputs
of an AV receiver by means of an RCA cable, the following assignment of the unbalanced input (Analog Line) must be made:
Centre = left OR right input, Surround Left = left input, Surround Right = right input�
Menu Settings