41
Deutsch
English
The red LED of the remote control is
flashing
The remote control does not work
(no LED light)
1. The DM system is not switched on at the mains
2. The distance between the DM system and the
remote control is too great
3. The battery of the remote control is almost dead
4. The processor of the DM system or the remote
control has shut down
5. The remote control is not registered with the DM
system
1. The battery is dead
2. The battery has been inserted incorrectly
1. Connect the DM to the mains and switch the
power to ON
2. Reduce the distance to the DM system
3. Change the battery (CR 2450)
4. Switch the DM system power off for approx.
10 seconds or take the battery out of the
remote control for at least 10 seconds
5. Follow the steps described in „Registering the
remote control with the DM“
1. Change the battery (CR 2450)
2. Insert the battery correctly
Error
Possible causes
Solutions
General care and maintenance
To ensure that you enjoy your Canton loudspeakers for a very long
time please note the following care and maintenance instructions: Do
not expose the cabinet of the loudspeaker to direct sunlight. Avoid
extreme changes in temperature and protect your loudspeaker from
moisture. Do not use abrasive or alcohol-based cleaning agents. The
surface of the cabinet can be wiped clean with a lint-free cloth.
Running-in time
In order to develop its maximum performance ability a loudspeaker
needs a running-in time of approx 15 – 20 running hours. In this time
the characteristics of all the mechanical parts alter to reach the values
set during the development of the loudspeaker, i.e. the suspension of
the chassis becomes freer, improving the reproduction quality.
DM70_Manual2008.pmd
09.10.2008, 12:04
41
