Installation Instructions Model : Z3314--44
Further information Phone (03) 9761 4603 [email protected]
❺
❻
Feed the cover plate
13
, onto the Diverter
body, until it is flush with the counter top
surface.
Thread the retaining flange and handle
14,
onto the Diverter spline, securing it firmly by
hand only. See the “Removing and replacing a
handle”, on page “12” for additional details.
Insert the hand spray escutcheon
15
, into the
cut out hole.
Install the rubber gasket
16
, onto the
escutcheon thread extension, followed by the
brass lock nut
17
. Secure on to the worktop
underside, but do not over tighten.
5
❹
Thread the bottom brass lock nut
9
, followed
by the bottom rubber washer
10
, onto the
Diverter body
8
, thread section.
Insert the Diverter body
8
, through the tap
hole cut out in the counter top.
Feed the top rubber washer
11
over the
thread section followed by the top brass lock
nut
12
.
Adjust the Diverter body to the correct height
and then tighten using a 32mm spanner or
adjustable smooth jawed shifter.
Note: Make sure that the locking nuts are
fully tightened, otherwise the Diverter body
may turn while turning the Diverter lever.
Continue…….
