8
INSTALLATION INSTRUCTIONS
IMPORTANT
(PALESE READ CAREFULLY)
Installing
Mount machine securely to solid, even base foundation. Concrete base mounting preferred. Locate in clean, dry, well
lighted and well ventilated building if possible. With machine in position, test table surface lengthwise and crosswise
with machinist level. Place metal shims under low corners. Check that all four corners are supported.
Grounding Information And Power Connections
1.
** IMPORTANT **
Before connecting to the power source, be sure that the voltage is the same characteristics as tied on terminal
box.
RUNNING ON WRONG VOLTAGE WILL INJURY THE MOTOR
2.
The necessary wiring to the power source should be completed by a competent electrician.
For personal safety, this machine must be properly grounded. Base of machine should be grounded to central
grounding system.
3.
NOTE: After wiring into the power source, run motor without load to check the direction of rotation.
4.
Please refer to Fig. 2, Fig. 3 of Control Panel and Connections To Power source.
CONTROL PANEL
Fig. 2
Fig. 3
CONNECTION TO POWER SOURCE
NOTE: SELECT WIRE SIZE TO MEET TOOL
REQUIRED AMPERAGE OF
34.5AMP/220V
17.25AMP/440V
