10
Disconnect machine from the power source before adjusting this machine.
Table Rollers
The table rollers are adjusted to the proper height with the quick-set handle mounted on the right side of the work
table. As a general rule, when planning rough stock, the table rollers should be set at high position, and when
planning smooth stock, the table rollers should be set at low position.
NOTE: The table rollers must always be set parallel to the work table.
1.
Quick adjustment for planning rough stock and smooth stock:
A.
Loosen lock handle (A) and move adjusting handle (B) up to the expected position as shown in Fig. 6
B.
Lock handle (A).
2.
Table rollers can be adjusted depending on working situation. However, the Max adjustment height is .125"as
shown in Fig. 7.
The Depth of Cut
This planer is equipped with easy-to-read digital thickness display and a thickness scale. Cutting thickness is up to
11-13/16". Power table up and down travel makes it easy to select desired material thickness.
When power table reaches the approximate material size, using the micro adjustment adjust (A) for manual
positioning. The digital display displays increments of .001" see Fig. 8
Fig. 6
A.
Lock Handle
B.
Adjusting Handle
Fig. 7
Fig. 8
A.
Manual Micro Adjustment
B.
Thickness Scale
C.
Digital Display
