Canon Z5000, Configuration Manual

Page: 95 / 168

4
4-11 Network Setup
Unlike remote Setup, local Setup does not provide separate settings to enable a
protocol and to configure it. For example, remote Setup has two settings for
AppleTalk: one to enable AppleTalk, and the other to set the AppleTalk zone. In
local Setup, there is only the setting for AppleTalk zone. By default, the AppleTalk,
IPX/SPX, and TCP/IP protocols are installed and enabled. You can verify a protocol
is enabled in the Bindings tab of the Network Control Panel.
T
O CHANGE PROTOCOL SETTINGS IN LOCAL
S
ETUP
:
1. Click the Modify or Advanced button next to the setting.
The Windows NT Network Control Panel opens.
2. Click the Protocols tab.
3. Select the protocol to modify.
Unless you have installed additional protocols, the choices are AppleTalk, NWLink
IPX/SPX Compatible Transport, and TCP/IP.
4. Click Properties, make your selections, and click Apply.
5. Click OK to close the Properties dialog box.
6. Click OK to close the Network dialog box.
If you have disabled any of the protocols in this procedure, use the Bindings tab of the
Windows NT Network Control Panel when you are ready to re-enable the protocols.