Canon PIXMA MP170, Service Manual

Page: 11 / 70

2. LIST OF ERROR DISPLAY / INDICATIONS
Errors and warnings are displayed by the following ways:
1) Operator call errors are indicated by the Alarm LED lit. (In the service mode, the Alarm LED blinks to indicate
errors.)
Service call errors are indicated by the number of cycles the Alarm and Power LEDs blink.
2) Errors and warnings are displayed on the LCD on the operation panel.
3) Warnings are displayed on the MP driver Status Monitor.
2-1. Operator Call Errors (by Alarm LED Lit in Orange)
MP450 LCD
MP170 LCD
Alarm LED
blinking in
orange (in
the service
mode only)
Error [Error code]
Solution Remarks
There is no
paper.
LOAD PAPER 2 times
No paper. (ASF)
[1000] Set the paper in the
ASF, and press the OK
button.
The paper is
jammed.
PAPER JAMMED 3 times
Paper jam. [1300] Remove the jammed
paper, and press the OK
button.
Ink has run out.
Replace the ink
cartridge and
close the cover.
U041
CHECK INK
U041
- No ink. [1600] Replace the empty ink
cartridge(s), or press
the OK button. Pressing the OK
button will exit the
error without ink
cartridge replacement,
however, ink may run
out during printing.
The following
ink cartridge
cannot be
recognized.
U051 / U059 CHECK INK
U051 / U059
5 times
Ink cartridge not
installed. [1401]
Ink cartridge not
for this model
installed. [1485] Confirm that the ink
cartridges are for this
model, install them
properly, then close the
scanning unit.
The following
ink cartridge
cannot be
recognized.
U052
CHECK INK
U052
15 times
Ink cartridge not
installed. [1682] Re-install the
applicable ink cartridge
(s) properly, and close
the scanning unit.
Or, with the ink
cartridges installed,
turn the machine off
and on again.
The following
ink cartridge
cannot be
recognized.
U053
CHECK INK
U053
4 times
Improper
installation of an
ink cartridge.
[1687] Re-install the
applicable ink cartridge
(s) properly, and close
the scanning unit.
The waste ink
absorber is
almost full. WASTE INK
NEAR FULL - Warning: The
waste ink absorber
becomes almost
full.
[1700 for the main
waste ink
absorber, 1710 for
the platen waste
ink absorber] Pressing the OK button
will clear the error, and
enable printing.
At repair
*1
:
For main waste ink
absorber replacement,
replace
- the bottom case unit
(MP170: QM2-2800
MP450: QM2-2814),
or
- the ink absorber kit
(MP170: QY5-0149
The service call error,
indicating the waste
ink absorber is full, is
likely to occur soon.
1-4