(13/80)
QY8-13EX-040
*1
: For the G2000 series and the G3000 series only.
*2
: For the G3000 series only.
Note: 1. Before replacement of the
main PCB ass’y
, check the ink absorber counter value, and register
it to the replaced new
main PCB ass’y
. (The value can be set in 10% increments.)
In addition, according to the "
Guideline for Preventive Replacement of Ink Absorber
," replace the
ink absorber. For details, see
3-5. (2) Preventive replacement of ink absorber.
Cycles
of lamp
blinking
Error
Error
code
Check points & Solution
USBPRT bulk-in bus
error
[6933]
USBSCN bulk-out bus
error
[6936]
USBSCN bulk-in bus
error
[6937]
USBSCN interrupt-in
bus error
[6938]
28 times USB sub-system
firmware error
[6940] (1) The error is reproduced after powering off the printer and powering
it on again.
-> Replace the main PCB ass’y.
USB sub-system
command error
[6941]
USB sub-system data
copy error
[6943]
USB sub-system
instruction error
[6944]
USB sub-system not
started properly
[6945]
USB sub-system
improper timeout
setting
[6946]
29 times USB sub-system
timeout
[6942] (1) The error is reproduced after powering off the printer and powering
it on again.
-> Replace the main PCB ass’y.
easyfixs.blogspot.com
Summary of Contents for Pixma G1000 series
