(11/80)
QY8-13EX-040
Cycles
of lamp
blinking
Error
Error
code
Check points & Solution
7 times Ink absorber full
[5B00] (1) The error is reproduced after powering off the printer and powering
it
on again.
-> Replace the partial or whole absorber kit.
8 times Print head temperature
too high
[5200] (1) Printing is performed though ink is used up.
-> Replenish ink tanks with ink.
(2) The cartridge is defective (the contacts, the TAB wires, or the
surroundings of the nozzles are burnt, etc.).
-> Replace the cartridge.
(3) The contact pins of the carriage unit are bent or deformed.
-> Replace the carriage unit.
If the error still occurs, replace the following:
- Main PCB ass’y
9 times NVRAM error
[6800] (1) The error is reproduced after powering off the printer and powering
it on again.
-> Replace the main PCB ass’y.
NVRAM timeout
[6801]
10 times Discharge VH monitor
error
[B202] (1) The Carriage FFC is disconnected or connected at an angle.
-> Connect the Carriage FFC properly.
(2) The error is reproduced after removing the cartridge, powering off
the printer and powering it on again.
-> Replace the main PCB ass’y.
(3) The error is reproduced after re-installing the cartridge.
-> Replace the cartridge.
Pre-charge VH monitor
error
[B203] (1) The Carriage FFC is disconnected or connected at an angle.
-> Connect the carriage FFC properly.
(2) The DC harness is not connected properly.
-> Connect it properly.
(3) If the error still occurs, replace the cartridge.
-> Replace the cartridge.
If the error still occurs, replace the following:
- Main PCB ass’y
- Power supply unit
FET-on VH monitor
error
[B204] (1) The carriage FFC is disconnected or connected at an angle.
-> Connect the carriage FFC properly.
(2) Remove the cartridge, power off the printer and power it on again.
-> If the error still occurs, replace the main PCB ass’y.
(3) The error is reproduced after re-installing the cartridge.
-> Replace the cartridge.
If the error still occurs, replace the following:
- Power supply unit
VHIC status monitor
error
[B205] (1) The contact pins of the carriage unit are bent or deformed.
-> Replace the carriage unit.
If the error still occurs, replace the following:
- Cartridge
- Main PCB ass’y
- Power supply unit
20 times Other hardware errors [6500] (1) The error is reproduced after disconnecting the power cord and
connecting it again (hard-power-off and on).
-> Replace the main PCB ass’y.
easyfixs.blogspot.com
Summary of Contents for Pixma G1000 series
