Canon Paper Deck-V1, Service Manual

Page: 55 / 90

Chapter 3
3-13
3.3.4.3 Stringing the Lifter
Cable
0009-2105
1) Check to make sure that the lifter drive shaft [1] and
the lifter [2] are fixed in place using a hex wrench
[3] and 2 long screwdrivers [4], respectively.
2) Fix the 4 cable fixing plates [5] in place to the lifter
using 2 screws each.
3) Hook the lifer cable [6] on the 4 pulleys [7] above.
4) Hook the ball of the lifter cable on the 2 front/rear
pulleys [8] of the lifter drive shaft; then, wind it
about 1.5 times along the groove of the pulley.
At this time, be sure to keep the lifter cable taut so that
the long drivers used to keep the lifter are slightly
lifted by the cable.
5) Fix the 2 pulleys [5] in place to the lifter drive shaft
with a set screw [9] (1 pc. each).
6) Fit all removed pulleys to the lifter shaft; then,
measure the height A from the base plate of the
compartment to the top face of the lifter, thus
making sure that the lifter is level.
F-3-48
3.3.5
Lifter Cable
3.3.5.1 Opening the
Compartment
0009-2106
1) Push the deck release grip to detach the deck from
its host machine. Then, push down the latch plate
[1] found at the rear left to open the compartment
[2].
F-3-49
3.3.5.2
Removing the
Compartment
0009-2107
1) Place a stack of paper [3] (about 8 cm in height) on
the floor on which to place the deck [2], thus
preventing damage to the roll support plate [1].
F-3-50
2) Push the deck release grip to detach the deck from
its host machine; then, push down the latch plate [1]
found at the rear left to open the compartment [2].
[4]
[8]
[9]
[5]
[7]
[7]
[1]
[5]
[9]
[8]
[3]
[5]
[6]
[5]
[A]
[A]
[A]
[2]
[A]
(rear)
[2]
[1]
about 8cm
[2]
[3]
[3]
[1]