Canon Paper Deck-V1, Service Manual

Page: 51 / 90

Chapter 3
3-9
F-3-32
3.3.3 Deck Lifter Motor
3.3.3.1 Opening the
Compartment
0009-2097
1) Push the deck release grip to detach the deck from
its host machine. Then, push down the latch plate
[1] found at the rear left to open the compartment
[2].
F-3-33
3.3.3.2 Positioning the Deck
Lifter
0009-2099
1) If there is any paper, remove all.
2) Turn on the host machine's power switch.
3) If the deck lifter is in its up position, move it so that
the distance from the bottom plate of the
compartment of the deck lifter is about 7 cm. Push
the sensor flag [2] of the paper supply position
sensor found inside the compartment [1] so that the
deck lifter moves down. (The deck lifter will stop as
soon as you release the flag.)
Insert a hex wrench [4] into the hole of the lifter drive
shaft [3] to fix it in place (against turning).
F-3-34
F-3-35
4) Disconnect the power plug, and turn off the host
machine's power switch.
3.3.3.3
Removing the
Compartment
0009-2100
1) Place a stack of paper [3] (about 8 cm in height) on
the floor on which to place the deck [2], thus
preventing damage to the roll support plate [1].
[1] [2]
[2]
[3]
(rear)
[2]
[1]
[1] [2]
about 7cm
[3]
[4]