Canon oce 31x5e, Daily Maintenance

Page: 36 / 137

36 Océ 31x5E Copy jobs & daily maintenance
Stapling copies
The finisher of the Océ 31x5E is provided with a stapler that can automatically
staple up to 30 or 50 sheets of 8.5 x 11”
20 lb. bond paper (depending on the
machine version).
Copies in other sizes must be stapled by hand. The stapling slot is identified
with a
‘
’.
If you wish to remove a staple from a stack of copies or originals, you can use
the staple remover which is located in the cover of the automatic document
feeder. This device consists of a pin for opening staples and a tray to collect the
staples.
▼
Automatically stapling a set of copies
1
Place the entire set of originals face down against the left side of the tray in the
automatic document feeder.
Note:
The originals must all be the same size and must not be too bent or
wrinkled. See also ‘Originals that can be used’ on page 94. Remove any
paper clips and staples. Make sure all pages are separated from each other.
2
Adjust the original guides, if necessary, until they almost touch the set of
originals.
3
Indicate whether the originals are 1- or 2-sided and choose 1- or 2-sided copies
using the ‘Original’ and ‘Copy’ function buttons.
4
Using the ‘Staple’ button, select ‘Yes’.
5
Enter the desired number of copies using the copy quantity buttons.
6
Press the start button ( ).
Note:
In order to staple 8.5 x 11” copies automatically, feed the
originals in portrait orientation into the automatic feeder. If the staple is
in the wrong corner of the copies, turn the originals 180
q
.
▼
Stapling copies by hand
1
Make sure that there are no jobs in progress.
Attention:
If you use the stapler while the machine is processing a finisher
job, you may cause paper jams in the finisher. This, however, does not apply
to machines with a 50-sheet stapler.