CHAPTER 5 SERVICE MODE
5-84
CONFIG
Use it to select any of the multiple pieces of firmware stored on the hard
disk to suit the selected destination and paper size:
Settings
XXYYZZAA
XX: country (JP), YY: language (ja), ZZ (00): destination, AA (00): paper
configuration
The method of indication COPIER>DISPLAY>USER>LANGUAGE.
The selections in parentheses are default selections; for the country and the
languages, names are given.
Using the Mode
1) Select <CONFIG>.
2) Select the item to change (to highlight), and press the +/- key.
3) Each press on the +/- key move the selection to the next item.
4) When the desired item is indicated, press the OK key.
5) Turn off and then on the main power switch.
SHARP
Use it to change the level of sharpness of soft the image.
•
A higher setting makes the image sharper.
Settings
1 to 5 (default: 3)
COTDPC-D
for factory.
Settings
0 to 3 (default: 0)
DF-BLINE
Use it to enable or disable black line reduction mode (disabling edge em-
phasis) for stream reading.
Caution
When enabled, the black lines will be less conspicuous but the edges of the
images will be less crisp.
Settings
0: disable (default)
1: enable
FIX-SMR
Use it to set the fixing trail removal mode in a high humidity environment.
Caution
When ‘1’ is set, the following will occur:
•
The laser intensity will be reduced by 50 V.
•
The fixing film control speed is changed from 539 to 535 m/sec.
•
The fixing/feeding speed is reduced:
B4:
from 14
→
10 ppm
B5R:
from 28
→
15 ppm
LGL:
from 14
→
10 ppm
A4R,etc.:
from 18
→
10 ppm
Settings
0: disable (default)
1: enable
COPIER>OPTION>BODY