Canon Inner Finisher-J1, Service Manual

Page: 64 / 101

CAUTION:
Points to Note when Installing the Upper Feed Guide
Unit
When attaching the Upper Feed Guide Unit [1], keep
standing the Feed Guide [2] as shown in the figure.
[1]
[2]
Removing the Processing
Tray Unit
■ Preparation
1. Remove this machine from the host machine.
“Removing this Machine from the Host Machine” on
page 43
2. Remove the Front Cover Unit. “Removing the Front
Cover Unit” on page 54
3. Remove the Rear Cover. “Removing the Rear Cover”
on page 54
4. Remove the Delivery Tray. “Removing the Delivery
Tray” on page 54
5. Remove the Upper Feed Guide Unit. “Removing the
Upper Feed Guide Unit” on page 57
6. Remove the Tray Guide Cover. “Removing the Tray
Guide Cover” on page 55
7. Remove the Staple-free Staple Unit. “Removing the
Staple-free Staple Unit” on page 63
■ Procedure
1. Remove the Front Tray Rack [1] / Rear Tray Rack [2].
[1]
[2]
NOTE:
How to assemble the Front Tray Rack and Rear Tray Rack
1. Insert the Front Tray Rack [1] and Rear Tray Rack [2]
at the Guide.
2. Release the latch and move the Tray Rack to the
bottom.
3. Check the phase position between the Front Tray
Rack [1] and Rear Tray Rack [2] with the marking line
on them. Align the end face of the Front Tray Rack
[1] with the marking line [A] at the front side. Then, be
sure to check that the end face of the Rear Tray Rack
[2] is in the gap [B] between the marking line at the
rear side. When the phase position is different, follow
the step 1) again.
[1]
[2]
[A]
[B]
2. Remove the Cable Guide [1].
• 1 Screw [2]
• 3 Connectors [3]
• 2 Cables [4]
1x 2x 3x
[1]
[2]
[3]
[4]
4. Disassembly/Assembly
58