Canon imageRUNNER 2520 Series, Service Manual, Page: 340 / 402

22. Attach the rear cover(left). (3 Screws)
CAUTION:
Put the relay harness through the cut portion of the rear
cover(right).
■ b. When Installing the Card Reader
and the USB Application 3-Port
Interface Kit-A1 at the same time.
1. Install the USB Application 3-Port Interface Kit-A1.
2. Remove the harness cover of the USB Application 3-
Port Interface Kit-A1.
• 2 Claws
&ODZ
&ODZ
3. Perform steps 1) to 9) of "a. When installing the card
reader in a simple substance ".
4. Attach the card reader.
• 2 Screws ( TP ; M4x16 )
2x
730[
5. Perform steps 11) to 12) of " a. When installing the
card reader in a simple substance ".
6. Route the cable to the USB cable guide.
7. Perform steps 15) to 18) and steps 20) to 22) of " a.
When installing the card reader in a simple
substance ".
8. Attach the cable cover of USB Application 3-Port
Interface Kit-A1.
Registering the Card IDs
After installing the Card Reader, register the card numbers
to be used in the service mode of the host machine.
If they are not registered, cards will not be recognized when
inserted.
9. Installation
330