CHAPTER 3 MECHANICAL SYSTEM
COPYRIGHT © 1999 CANON INC.
CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
3-5
Figure 3-110
D.
Adjusting the Height
You may have to adjust the height of the
machine to ensure that it will remain aligned
with its host copier. As necessary, perform the
following:
D.1 Checking the Height
1) Compare the top of the upper cover of the
machine and the top of the upper cover of
the copier. If the difference in height is not
as indicated in Figures 3-112 and -113,
make adjustments. (Also, if jams occur fre-
quently at the inlet to the finisher, make a
check to see if the height is the cause.)
The height of the machine may be changed
by adjusting the height of the casters
shown in Figure 3-110.
2) When adjusting the rear left caster, remove
the connector cover [1] (one screw [2] ).
Figure 3-111
[2]
[1]
